So i took an old warped sports angel lcd and dropped an icd b2k4 wireing harness with eyes into it.
start
finish
dis assembly
old and new board/battery set up
bought roller micro switch... very smooth.
cut plexi insert for switch mounting and battery holder.
cut board to fit better- tested board out on my b2k4 and it works fine.
-So i didnt want to wait any longer, so i robbed the harness off of my b2k4.
well it fires. iam having problems with the lpr. when i add a larger spacer it leaks but shoots fine. but with out the spacer it doesnt cycle all the way and hit the poppet.
This is a video of it just cycling enough to poop out the reballs.
here is a vid with a different reg and a washer as an internal spacer.
noid leaks. but shoots very well. reg set to 275 psi and this is a HP angel, works pretty well
finishing the eye covers.....
broken tap....
with custom spacer in lpr, and volie. this HP angel is currently running in the 300psi range, with no shoot down... haven't had it chrono'd but its close maybe a +-15 fps.
Final Build cost.
angel lcd fried-$40
ICD harness-$30
dye excell barrel-$11 on the way
lowrise feedneck-$6.75
kapp vollies-$10.50
trigger switch,tap,brass,accessories-$30
total-$128.25
shoots AMAZZZING- priceless.
thanks for looking
